CAUTION: DO NOT REMOVE FOAM PROTECTING THE TIMER, AS THE BUTTONS MAY TEAR WHEN TURNING THE BED OVER.Ģ. Turn bench over so it is standing on the legs. Side skirt installs behind front skirt with the 8 screws provided (you should be able to see into the slotted louvres). Attach the pistons to the ball stud at each end (the smaller shaft is attached to the bench).ġC.Attach front skirt and side skirt. Remove the eight 5/16' x 1 ' bolts from the bench panel.ġB.Remove the 42' x 16' pieces of styrofoam from the box and place them across the bench rails (or use 2x4's). Place lounge, bulbs facing down, on a soft surface. General Overview w/ Ballasts & CapacitorsĬlick here for a picture of electrical outlet placementĬlick here for a picture of ideal in-room bed placementġA.Remove lounge from box. As always, please call with any questions ph. In this instance these pictures can be invaluable in locating the correct part. We recognize that you are new to the tanning industry and might not know what all the components look like in a tanning bed. In many cases the replacement parts are small and easily accessible and can be replaced by you or your staff. Occasionally your tanning bed may need to be repaired or parts replaced. This page was designed to assist you in repairing your tanning bed.
